Communications with Broccoli

Good evening everyone. I am a computer engineering student at the University of Florence and I was assigned a project for my thesis.
Basically I have 2 devices, udoo board and OpenMote, which must communicate with each other. OpenMote is my sensor network and udoo is my base station. So when OpenMote detects something odd in the network sends a signal to the base station. My problem is that OpenMote is a small device with low memory and little RAM which requires flash to load programs written in C exclusively. So as you understand I cannot install completely Bro but I have to work through the Broccoli library and I don’t know how to write the program that does what I wrote above. Do you have any idea?

Hi Albert,

Broccoli is only a communication library for talking with Bro; it itself
does not do any detection. So even if you could compile broccoli on your
OpenMote (which I doubt a little bit), it would not do any traffic

Apart from that I doubt we are supporting the protocols spoken in such
networks (assuming it uses zigbee or sth. like that).

So - you probably have to write something yourself here, unless I
misunderstand your use-case.